Commercial Printing Training

Domino UK offers a range of training courses designed specifically for the Commercial Printing sector.  Typically 3 day Operator courses for the JetArray and BitJet, along with 3 day courses for the controller systems, Editor 2 and Editor GT.  In addition, Engineer courses are available which will enable your site maintenance staff to carry out first line maintenance and if required, scheduled servicing on your machines too.

For complete system operator training the print engine and controller courses can be merged into one 5 day course that will give your operators a good basic knowledge of the whole system giving them understanding and confidence to utilise your Domino System.

Courses can be run at the dedicated UK CP Training Centre or your site utilising your own Domino system.  A popular combination for courses is to cover the print engine at Cambridge and then return to your site to cover the controller.  This has the added advantage of  giving the trainees the quiet atmosphere of the Cambridge Training Centre whilst the intricacies of the print engine are covered, and the reality of the students own system when moving onto the controller and running the complete integrated system on their own line.

In Addition to the basic courses, Domino offers Refresher and Best Practice courses for the experienced Operators.  These courses will enhance the knowledge that your Operators already have and will improve their ability to run the systems more efficiently and get more out of your Domino System.

The following are basic outlines of the courses available. 

Ink Jet Print Engine Operator Syllabus Outline

• Introduction to Bitjet
• Start up and Shutdown Procedures
• Operator maintenance
• Interconnections
• Machine Set Up
• Practical Exercises
• Course Debrief and Presentation

Controller Operator Syllabus Outline

• Introduction to Controller
• Switch on and Shut Down of System
• System Menus
• Configuration
• Selecting an Address File
• Selecting a Layout
• Opening a Job
• Printing the Job
• On Line Print Adjustments
• Final Practical Exercises
• Course Debrief and Presentation

BitJet Engineer Syllabus Outline

• Binary Inkjet Theory
• Introduction To Bitjet
• Auto Start Procedure
• Manual Start and Shutdown Procedure
• Basic Head Maintenance
• Ink System
• Electronics System
• Basic Print Head Module Set Up Procedures
• Domino Signature Editor
• Final Practical Exercises
• Course Debrief and Presentation

JetArray Engineer Syllabus Outline

• Introduction to JetArray
• Start up and Shutdown Procedures
• Operator maintenance
• Machine Service
• Practical Exercises
• Course Debrief and Presentation

Print Engine/Controller Operator Refresher Syllabus Outline

• Introduction
• Basic System Diagram
• Assessment of Current Methods Used
• Current Start Up Procedures
• Operator maintenance
• Practical Exercises
• Course Debrief and Presentation

Print Engine/Controller Operator Best Practices Syllabus Outline

• Introduction
• Basic System Diagram
• Assessment of Current Methods Used
• Best Practices
• Practical Exercises
• Course Debrief and Presentation

For more information contact the UK CP Training Manager at julian.knight@domino-uk.com, or print and complete the Fax Back Form and send to Julian Knight at 01954 782874: